matte car wrap maintenance Full coverage: Window Installation without Removing Molding

matte car wrap maintenance

Wrapping vinyl wrap around windows can be frustrating. Wrapping is easier when the molding is removed. Some cars' moldings are just rubber. This is okay. matte car wrap maintenance Some vehicles have metal in the rubber molding so it is possible to bend the metal. Some side windows of Jeep have both the cases. matte car wrap maintenance Let's take this example as an example to answer the question: Can you do a complete coverage without removing any molding?

Most installers will find Jeep's window to wrap with vinyl wrap film the most difficult. White cars can make it even more challenging. matte car wrap maintenance The window can be opened or closed. There are two parts to it. The rubber on the upper and side moldings is all rubber. This allows the installer to easily remove it and place it behind the window. It is the bottom of the molding with the metal inside. You must first clean and prep the window to ensure that it covers all of its area. Make sure to clean the window completely with alcohol. Once you have finished cleaning, you can begin to prep the molding. To lower the surface energy, first tape masking tape around the bottom molding. Run knifeless tape about half an inch beyond the edge to cover the upper and side moldings around the fixed window. These are the two parts that the installer should deal with last. The other side molding, which is located around the open windows, should be ripped off and tucked behind the window. After all the preparation is complete, you can cover the entire window with a large panel of vinyl wrap. matte car wrap maintenance Attach it to the window and you can start making glass. Then you can make a relief cut. You can trim the panel to about two-three inches from the sides. This will leave you with enough material for other projects. To heat the material around its edge, use your finger to push it into the recessed space. You should start at the top of the window and work your way down to the bottom. Once you reach the bottom, use a squeegee or a knife to insert the material. Make a second relief cut. matte car wrap maintenance This will be the cut at the bottom of the section (at the end the masking tape, on the open side). This is so that you can pick up the film from the side and then tuck it into place. It is important that the film be cut at a 45 degree angle to ensure you have enough material for all your work. Once you have made the cut, you can use your squeegee for the material to be inserted into the space. Make another relief cut on the opposite side. Then, use your squeegee to tuck the film back in. Make sure that the material is properly inserted. After it's done, click the blade to sharpen it. Now you can do a sneaky light cutting. Cut at an angle of about an eighth inch above the gap in the bottom. matte car wrap maintenanceYou have a small chance of cutting directly onto the paint. However, there is masking tape underneath. Once you are done cutting, remove the excess material and use a micro-squeegee for a deeper slide. You can then seal the area with the micro squeegee by making one more cut. The bottom will now be fully covered. You can now handle the section of the fixed window. Once again, heat the area around the edge by pressing your finger into the recessed areas. Once you are done forming, remove the knifeless tape at the bottom and pull out the excess material. This side's rubber molding is often very soft so you can easily pull it off and feed the material underneath. www.vinylcarwrapshop.com matte car wrap maintenance It is important to take your time, working from the top to the bottom. Once you are done, you can remove any excess film. Make sure to seal the edges of the film. With enough patience and great technique you can now wrap your window completely without having to remove the molding. This is both safe and durable. Installation TeckWrap Window molding Wrap tips